The XA-16 was a redesignated Northrop YA-13 following an engine change.
XA-16 was the final designation of the aircraft originally built as the Northrop Gamma 2C. The Gamma 2C was a company funded demonstrator based on the Northrop Gamma 2A and 2B designs. These early designs were primarily designed as racers or for speed record attempts. The cockpits both of the 2A and 2B aircraft were far back on the fuselage near the tail, but for the Gamma ...
more
Read article at Wikipedia
Northrop XA-16
Aircraft
Manufacturer
Northrop Corporation
The Northrop Corporation was a leading United States aircraft manufacturer from its formation in 1939 until its merger with Grumman to form Northrop Grumman in 1994. The company is known for its development of the flying wing design, although only a few of these have entered service.
Jack Northrop...
Used By
Similar topics in Freebase
-
X-4 Bantam
The X-4 Bantam was a prototype small twin-jet airplane in 1948, manufactured by Northrop. It had no horizontal tail surfaces, depending instead on combined elevator and aileron control surfaces (called elevons) for control in pitch and roll attitudes, almost exactly in the manner of the similar... -
Northrop YB-35
The Northrop YB-35 was an experimental heavy bomber aircraft developed for the United States Army Air Forces during and shortly after World War II by the Northrop Corporation. It was the first bomber to use the radical and potentially very efficient flying wing design, in which the tail section and... -
Northrop BT
The Northrop BT was a two seat, single engine, monoplane, dive bomber built by the Northrop Corporation for the United States Navy. At the time Northrop was a subsidiary of the Douglas Aircraft Company. The design of the initial version began in 1935. A 700 hp (522 kW) Pratt and Whitney XR-1535-66... -
Northrop HL-10
The Northrop HL-10 was one of five heavyweight lifting body designs flown at NASA's Flight Research Center (FRC--later Dryden Flight Research Center), Edwards, California, from July 1966 to November 1975 to study and validate the concept of safely maneuvering and landing a low lift-over-drag... -
T-38 Talon
The Northrop T-38 Talon is an American supersonic jet trainer. It was the world's first supersonic trainer and to date, is also the most produced. It remains in service as of 2009 in air forces throughout the world including the United States Air Force (USAF), which remains its largest user. The... -
XP-79 Flying Ram
The Northrop XP-79 "Flying Ram" was an ambitious American design for a flying wing fighter aircraft; it had several notable design features. Among these, the pilot would operate the aircraft from a prone position—permitting the pilot to withstand much greater g-forces—and welded magnesium monocoque...